[shortdesc]
- Deep Pour Epoxy Resin
- Specially formulated for up to a 2" depth pour
- UV resistance to prevent yellowing
- Excellent clarity
- 100% solids, No VOC's
- Produces a tough, high gloss, water resistant coating
- Food safe
- Ships within one business day
[/shortdesc]
[additional]DOWNLOAD: |
[/additional]
Deep Pour Epoxy Resin
ProGlas 1105 Deep Pour Epoxy Resin is a 100% solids, high versatile material commonly used for creating stunning, glossy crystal clear castings. Great for river tables, countertops, figurines and art pieces. It can be poured up to 2" thick per layer and is food safe
Proglas 1105 has been formulated for improved UV resistance to reduce yellowing and surface degradation from UV exposure.
**Not recommended in freezing climates due to possibility of de-lamination.
Procedure:
- Pour 2 parts by volume of the Part A and one Part B into the graduated cups. (If the resin comes out more like molasses than syrup, the resin is too cold.)
- Mix the resin with a stir stick. Stir steadily, scraping the sides and bottom. The resin will appear hazy but will clear up after 3 or 4 minutes.
- Apply the Seal Coat (not necessary for some surfaces): Pour some 1:1 table top epoxy resin on the surface (you do not want to use the Deep Pour for this) and spread it around with a foam brush or squeegee until a thin layer covers the whole surface. Allow the resin to cure for 4 hours before the flood coat is added. The seal coat will prevent most bubbles from forming during the flood stage.
- Apply the Flood Coat: Pour the mixed resin down the length of the surface. The resin will self-level and tools are not required. Allow the resin to run down the sides. Any drips that form along the bottom edge can be removed after the resin has cured. Flood coat can be up to 2” thick.
- Eliminating Air Bubbles: Once the flood coat has settled into place, take a torch or heat gun and wave the tool 6 to 8 inches above the surface. The bubbles will instantly start to pop. Repeat the process until all bubbles are gone. With Deep Pour, though, you typically don't get many air bubbles.
- Keep the room between 75 to 80 degrees during the curing process. It will take about 48-72 hours for the resin to become tack free, but full cure isn’t complete for another few weeks. If the temperature falls below 75 degrees, the cure time will lengthen. If too cold, the resin may never fully harden.
For more instructions and troubleshooting tips go .
